Latest Post on General Fabrication

Cone Layout Development by Marking and Calculation Method with Practical Example

We are going to explain this Cone layout in both Geometrical and Numerical Methods and at the end of learning this method, we have taken one practical Example of Full Cone Fabrication Layout Development to understand the use of this method for layout Development. We had also provided you example solution checking method using our Fabrication Calculator tool so that you can verify your calculation

0 Comments

August 24, 2020

General Fabrication / Pressure Vessels Fabrication

What is the Difference between Pipes and Tubes?

One of the foremost frequent questions we have in our mind is “Pipe and tube is the same or different”? Although pipes and tubes may look similar the fact is they are quite different in nomenclature and sizing, so we discussed all the differences between pipes and tubes in this post.

0 Comments

August 19, 2020

General Fabrication

ASME CODES AND SECTIONS

ASME - American Society of Mechanical Engineers. It is an International Boiler and Pressure Vessel Code is made of 12 sections and contains over 15 divisions and subsections.

0 Comments

April 30, 2018

General Fabrication

Procedure for Liquid Penetrate Test

SCOPE : To detect and evaluate the discontinuities open to the surface for wrought, forged materials and weldments of various size and shapes as required by construction drawing, by penetrate technique using be Solvent Removable Visible Color Contrast penetrate and non aqueous developer.

0 Comments

April 27, 2018

General Fabrication

Procedure For Tube to Tube-sheet Joint Expansion

Tube Expansion Procedure Scope: This Procedure describes and specifies the technique, acceptance standards, and documentation requirement for tube expansion in heat ex-changers.

0 Comments

April 27, 2018