Category «Heat Ex changer»

In this category All Post related to Heat Exchanger fabrication posted.

Fabrication Layout Development of Full Cone by Geometrical & Numerical Method with Example

Full cone development is most useful in fabrication of storage tank fabrication and some other vessel which are used for easy discharge of material from bottom outlet by utilizing gravity effect of the earth. So in this post we will discuss all the terms related to development of cone for lay outing same on to …

ASME CODES AND SECTIONS

ASME – American Society of Mechanical Engineers It is an International Boiler and Pressure Vessel Code is made of 12 sections and contains over 15 divisions and subsections. ASME Boiler and Pressure Vessel Code Sections I. Power Boilers II. Materials III. Rules for Construction of Nuclear Facility Components IV. Heating Boilers V. Nondestructive Examination VI. …

Procedure for Liquid Penetrate Test

SCOPE To detect and evaluate the discontinuities open to the surface for wrought, forged materials and weldments of various size and shapes as required by construction drawing, by penetrant technique using be Solvent Removable Visible Color Contrast penetrant and non aqueous developer. ┬áThis work instruction is applicable when the material and penetrant is within the …

Procedure For Tube to Tube-sheet Joint Expansion

Scope This Procedure describes and specifies the technique, acceptance standards, and documentation requirement for tube expansion in heat ex-changers. Reference. The current edition or addenda of the following documents has been referenced in the preparation of this procedure and shall be considered a part of this procedure as applicable TEMA ASME section VIII div. 1 …